HVAC Repair in Hoonah, AK
If your system quits, tell us what it's doing and a licensed contractor who covers Hoonah-Angoon Census Area will get in touch.
Tell us about the job
It takes about a minute.
Your furnace works every month of the year here
Hoonah doesn't get a summer off from heat and it never needs cooling at all. Winter nights average 27°F from December through February, and the furnace has to answer that cold for twelve straight months. Most homes here burn fuel oil to do it, and a system that never gets a break has less time to recover from a part wearing thin.
Storms are part of the load too. This area has seen 29 winter storms and 2 damaging wind events over the past ten years, and in Alaska overall, 21% of households lost power for at least 24 hours in 2024. When the power drops in weather this cold, a furnace that was already due for a repair often doesn't restart clean once it's back.
- 27°F
- the average winter night it heats against
- 63°F
- the average summer afternoon it cools against
Alaska requires contractors to register with the state.
Source: Alaska Department of Commerce, Community, and Economic Development
- Why is my heat not working?
- Start with the thermostat and the power to the furnace before assuming the worst. Check that the thermostat is set to heat and the temperature is above room level, and check the breaker and any switch on the furnace itself. If those are fine, the igniter or the flame sensor is a common failure point on a fuel-fired furnace, and with most homes here on fuel oil heat, an empty tank or a clogged filter will also stop it cold. Heat here isn't optional for a season, it's needed all year, so this is worth a same-day call if you can't find the problem yourself.
- Why is my system running but not cooling the house?
- If the system runs but the air isn't cold, check the filter first since a clogged one chokes airflow across the coil. Summer afternoons here only average 63°F, so most homes in Hoonah don't have central air conditioning at all, and what feels like weak cooling may just be a fan running without a cooling system behind it. If you do have air conditioning and it's blowing warm, a contractor needs to look at the refrigerant charge and the coil, since that's not something to diagnose from the thermostat.
- What can I check before calling for HVAC repair?
- Check the thermostat settings and batteries, the breaker for the system, and the filter, since these cause a real share of no-heat calls. Look at the furnace itself for a blinking light on the control board, and write down the pattern if there is one, since that code tells a contractor what failed before they arrive. If the power went out recently, some furnaces and thermostats need to be reset by hand rather than restarting on their own, and with storms knocking out power here more than a few times over the past decade, that's worth ruling out before assuming something broke.